Synthesis and Characterization of Photocrosslinked Biobased Polyester Membrane
DOI:
https://doi.org/10.11113/amst.v23n2.148Abstract
A series of bio-based photocrosslinked polyester membranes, poly(1,8-octanediol-itaconate-citrate-dodecandioate), (POSCI) were synthesized through polycondensation followed by photocrosslinking under UV irradiation in the presence of 2,2-dimethoxy-2-phenylacetophenone (DMPA) as photoinitiator (PI). Upon varied UV exposure time and DMPA content, the corresponding changes in chemical, structural, and mechanical properties of the polymer were studied. The transmission peak of FTIR spectrum centred at 1725 cm-1 indicates the formation of ester structure. Contact angle results suggested all of the synthesized POSCI membranes had hydrophilic properties as their contact angle is less than 90 °. Sol-gel analysis shows that the swelling ratio of POSCI decreases while the gel fraction increases with increasing in photocrosslinking time. The tensile strength of POSCI, thus, increased correspondingly with longer UV exposure. Excess DMPA, however, proved otherwise.
References
J. Dai, S. Ma, X. Liu, L. Han, Y. Wu, et al. 2015. Synthesis of Bio-Based Unsaturated Polyester Resins and Their Application in Waterborne Uv-Curable Coatings. Prog. Org. Coat. 78: 49-54.
I. Bechthold, K. Bretz, S. Kabasci, R. Kopitzky, And A. Springer. 2008. Succinic Acid: A New Platform Chemical for Biobased Polymers from Renewable Resources. Chem. Eng. Tech. 31: 647-654.
R. Wang, J. Zhang, H. Kang, and L. Zhang. 2016. Design, Preparation and Properties of Bio-Based Elastomer Composites Aiming at Engineering Applications. Comp. Sci. Tech. 133: 136-156.
A. L. Holmberg, K. H. Reno, R. P. Wool, and I. Epps, Thomas. 2014. Biobased Building Blocks for the Rational Design of Renewable Block Polymers. Soft Matter. 10: 7405-7424.
R. Wool and X. S. Sun. 2011. Bio-Based Polymers and Composites. Elsevier Science.
H. Tham Weng, U. Wahit Mat, R. Abdul Kadir Mohammed, W. Wong Tuck, and O. Hassan. 2016. Polyol-based Biodegradable Polyesters: A Short Review. Rev. Chem. Eng. 201.
D. Garlotta. 2001. A Literature Review of Poly (Lactic Acid). Journal of Polymers and the Environment. 9(2): 63-84.
M. Hartmann. 1998. High Molecular Weight Polylactic Acid Polymers. Biopolymers From Renewable Resources. Springer. 367-411.
A.-C. Albertsson And I. K. Varma. 2003. Recent Developments in Ring Opening Polymerization of Lactones for Biomedical Applications. Biomacromolecules. 4(6): 1466-1486.
K. M. Zia, A. Noreen, M. Zuber, S. Tabasum, and M. Mujahid. 2016. Recent Developments and Future Prospects on Bio-based Polyesters Derived From Renewable Resources: A Review. Int. J. Biol. Macromol. 82: 1028-1040.
B. Amsden. 2007. Curable, Biodegradable Elastomers: Emerging Biomaterials for Drug Delivery and Tissue Engineering. Soft Matter. 3(11): 1335-1348.
Y. Wang, Y. M. Kim, and R. Langer. 2003. In Vivo Degradation Characteristics of Poly(Glycerol Sebacate). J. Biomed. Mater. Res. A. 66A(1): 192-197.
D. G. Barrett, T. J. Merkel, J. C. Luft, and M. N. Yousaf, 2010. One-step Syntheses of Photocurable Polyesters Based on a Renewable Resource. Macromolecules. 43(23): 9660-9667.
Y. Wang, G. A. Ameer, B. J. Sheppard, and R. Langer. 2002. A Tough Biodegradable Elastomer. Nat. Biotechnol. 20: 602.
J. Yang, A. R. Webb, and G. A. Ameer. 2004. Novel Citric Acidbased Biodegradable Elastomers for Tissue Engineering. Adv. Mater. 16(6): 511-516.
J. M. Halpern, R. Urbanski, A. K. Weinstock, D. F. Iwig, R. T. Mathers, et al. 2014. A Biodegradable Thermoset Polymer Made by Esterification of Citric Acid and Glycerol. J. Biomed. Mater. Res. A. 102(5): 1467-1477.
B. G. Amsden, G. Misra, F. Gu, and H. M. Younes. 2004. Synthesis and Characterization of a Photo-Cross-Linked Biodegradable Elastomer. Biomacromolecules. 5(6): 2479-2486.
L. Huang, R. Jiang, J. Wu, J. Song, H. Bai, et al. 2017. Ultrafast Digital Printing Toward 4d Shape Changing Materials. Adv. Materials. 29(7): 1605390-N/A.
C. L. Nijst, J. P. Bruggeman, J. M. Karp, L. Ferreira, A. Zumbuehl, et al. 2007. Synthesis and Characterization of Photocurable Elastomers From Poly (Glycerol-Co-Sebacate). Biomacromolecules. 8(10): 3067-307
S. H. Lee, R. You, Y. I. Yoon, and W. H. Park. 2017. Preparation and Characterization of Acrylic Pressure-Sensitive Adhesives Based on Uv and Heat Curing Systems. Int. J. Adhes. Adhes. 75: 190-195.
Downloads
Published
How to Cite
Issue
Section
License
Copyright of articles that appear in Journal of Applied Membrane Science & Technology belongs exclusively to Penerbit Universiti Teknologi Malaysia (Penerbit UTM Press). This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.
